View By Product Type
View By Manufacturer
Overstock Sales
2 to 10 Amp
15 to 55 Amp
60 to 240 Amp
ELE Speed Controllers
Edge Lite
Edge Lite HV
Edge HV
Discontinued ESCs
Speed Controllers for Brushed Motors
Brushless Motor Connectors
Catalog > Speed Controllers & BECs > 15 to 55 Amp
Previous Item     Next Item     Show All Items       Add To Shopping Cart      
Cheetah 20A Brushless ESC
Item: 3 of 19  

Click on image for larger or alternate view.
  Weight:     19.7 grams / 0.70 oz.  
  Size:     45 x 24 x 9 mm / 1.77 x 0.94 x 0.4 in.  
  Constant Current:     20A  
  Max Current:     25A / 10 Sec.  
  FET:     12  
  BEC:     2A  
  TIMING:     Auto  
  PWM:     8KHz  
  Input:     2-3 cell Li-Poly or 4-10 Ni-MH  
  Low-Voltage Cutoff:     Auto - 3.0V / cell Li-Poly
  0.8V / cell NiCd/NiMH  
  • Low resistance
  • 8khz PWM
  • For 4-10 NiCd/NiMH cells, 2-3 Li-Poly Cells
  • 20A Max on 3 Li-Poly
  • User programmable brake
  • User programmable low-voltage cutoff (Lipo or NiCd/NiMH)
  • Throttle range self-adjusting
  • Soft start ramp up
  • Auto motor cutoff with reset
  • Safe power arming program ensures motor will not run accidentally after turn on
  • Low torque start
  • Auto shut down when signal is lost
  • Max RPM: 20,000 RPM with 14 pole motor
  • ~7" servo cable
  • BP 20A Brushless ESC Programming Guide
    Note: If using 4 servos with 3-cell Li-Poly batteries, you will need a 4.8V receiver pack or an external switching BEC to provide power to your receiver.
    Special Instructions: Never exceed the recommended battery voltage listed on the package. Do not use a separate battery supply with this controller. Never disconnect the battery supply when the motor is running. We strongly suggest that you use an overload fuse in the battery circuit. For example, a motor will run at 4 amps therefore a 5 amp speed controller is adequate. If the motor is stalled or stopped, with the power on, then it will draw 15 to 20 amps and burn out the speed controller. An overload fuse can prevent this type of damage. Also, the BEC provides a regulated power supply to the receiver. Usually about 0.5 amps. A stalled servo can draw 2 or 3 amps and damage the BEC which in turn can cause damage to the receiver.
    NOTE: BP Hobbies assumes no responsibility for the improper use and installation of this product.
    Price: $18.95
    Add To Shopping Cart    
    Prices, product specifications, and product availability are subject to change without notice.
    © Copyright 1998-2017, 2018 BP Hobbies, LLC. All rights reserved.