View By Product Type
View By Manufacturer
Overstock Sales
Closeouts
2 to 10 Amp
15 to 55 Amp
60 to 240 Amp
BECs
Cheetah
Thunderbird
Hydra
ELE Speed Controllers
Edge
Edge Lite
Edge Lite HV
Edge HV
Feigao
Discontinued ESCs
Speed Controllers for Brushed Motors
Brushless Motor Connectors
 
Catalog > Speed Controllers & BECs > 60 to 240 Amp
Previous Item     Next Item     Show All Items       Add To Shopping Cart      
Cheetah 60A OPTO Brushless ESC (No BEC)
Item: 1 of 28  

Click on image for larger or alternate view.
  Weight:     59.4 grams / 2.1 oz.  
  Size:     68 x 39 x 14 mm / 2.7 x 1.5 x 0.54 in.  
  Constant Current:     60A  
  Max Current:     70A / 10 Sec.  
  FET:     18  
  BEC:     None  
  TIMING:     Programmable - 1/7/15/30  
  PWM:     Programmable - 8/16K  
  Input:     2-7 cell Li-Poly or 6-20 Ni-MH  
  Low-Voltage Cutoff:     Programmable  
Features:
  • Finned aluminum heat sink
  • Low resistance, .0014 Ohms
  • 8-16KHz PWM
  • For 6-20 NiCd/NiMH cells, 2-7 Li-Poly Cells
  • 60A Max on 3 Li-Poly, 40A Max on 7 Li-Poly
  • User programmable brake
  • User programmable low-voltage cutoff
  • User programmable throttle settings and rotation direction
  • User programmable timing advance
  • User programmable PWM
  • Throttle range self-adjusting
  • Soft start ramp up
  • Auto motor cutoff with reset
  • Safe power arming program ensures motor will not run accidentally after turn on
  • Low torque start
  • Auto shut down when signal is lost
  • For outrunner motors, use 15° timing and 16Khz PWM
  • Note: This ESC has no built-in battery eliminator circuit (BEC). You will need a 4.8V receiver pack or an external switching BEC to provide power to your receiver.
    BP 60A Brushless ESC Programming Guide
    Special Instructions: Never exceed the recommended battery voltage listed on the package. Never disconnect the battery supply when the motor is running. We strongly suggest that you use an overload fuse in the battery circuit. For example, a motor will run at 4 amps therefore a 5 amp speed controller is adequate. If the motor is stalled or stopped, with the power on, then it will draw 15 to 20 amps and burn out the speed controller. An overload fuse can prevent this type of damage. Also, the BEC provides a regulated power supply to the receiver. Usually about .5 amps. A stalled servo can draw 2 or 3 amps and damage the BEC which in turn can cause damage to the receiver.
    NOTE: BP Hobbies assumes no responsibility for the improper use and installation of this product.
    Price: $31.95
    Add To Shopping Cart    
    Prices, product specifications, and product availability are subject to change without notice.
    © Copyright 1998-2013, 2014 BP Hobbies, LLC. All rights reserved.