View By Product Type View By Manufacturer Overstock Sales Closeouts Brushless ESC   2 to 10 Amp   15 to 55 Amp   60 to 240 Amp Brushed ESC   2 to 10 Amp   15 to 55 Amp Surface ESC Gyros, BECs and Electronics   Catalog > Speed Controllers > Brushless ESC > 60 to 240 Amp Previous Item     Next Item     Show All Items       BP 100A-HV Brushless ESC - CLOSEOUT SALE Item: 19 of 25   Click on image for larger or alternate view.   Weight:     157 grams / 5.53 oz.     Size:     90 x 53 x 23 mm   3.55 x 2.09 x 0.90 in.     Constant Current:     100A     Max Current:     125A / 5 Sec.     FET:     Many     BEC:     No     TIMING:     Programmable - 1/7/15/30     PWM:     Programmable - 8/16K     Input:     6-8 cell Li-Poly or 16-30 Ni-MH     Low-Voltage Cutoff:     Programmable   Features: Finned aluminum heat sink Low resistance 8-16KHz PWM For 16-30 NiCd/NiMH cells, 6-8 Li-Poly Cells 100A Continuous, 125A Max for 10 seconds 80A Continuous on 10 cell Li-Poly User programmable brake User programmable low-voltage cutoff User programmable throttle settings and rotation direction User programmable timing advance User programmable PWM Throttle range self-adjusting Soft start ramp up Auto motor cutoff with reset Safe power arming program ensures motor will not run accidentally after turn on Low torque start Auto shut down when signal is lost For outrunner motors, use 15° timing and 16Khz PWM Note: This ESC has no built-in battery eliminator circuit (BEC). You will need a 4.8V receiver pack or an external switching BEC to provide power to your receiver. BP 100A-HV Brushless ESC Programming Guide Special Instructions: Never exceed the recommended battery voltage listed on the package. Do not use a separate battery supply with this controller. Never disconnect the battery supply when the motor is running. We strongly suggest that you use an overload fuse in the battery circuit. For example, a motor will run at 4 amps therefore a 5 amp speed controller is adequate. If the motor is stalled or stopped, with the power on, then it will draw 15 to 20 amps and burn out the speed controller. An overload fuse can prevent this type of damage. Also, the BEC provides a regulated power supply to the receiver. Usually about .5 amps. A stalled servo can draw 2 or 3 amps and damage the BEC which in turn can cause damage to the receiver. NOTE: BP Hobbies assumes no responsibility for the improper use and installation of this product. Price: $53.98 Currently Out Of Stock - Notify Me When Available Prices, product specifications, and product availability are subject to change without notice. © Copyright 1998-2008, 2009 BP Hobbies, LLC. All rights reserved.