Previous Item     Next Item     Show All Items      
Lanyu Courser ARF - Blowout Closeout Sale
Item: 0 of 0  

Click on image for larger or alternate view.
  Wing Span     53.5 inches  
  Wing Area     395.25sq in  
  Length     40.55 inches  
  Weight     Airframe Weight: 3.48 pounds  
  Radio     4 channel  
  Power     .25 - .32 glow or 500 Watt Electric  
All wood built up construstion. A lot of old school in this kit! Very strong built high wing aircraft. This is a L-19 Bird Dog look a like. It has generous tail surfaces for stability. This is for intermediate pilots.
What this kit includes:
The ARF comes with all of the hardware that you need to complete the airplane. Included landing gear is sturdy aluminum. The cowl is fiberglass. Plastic heatshrink covering through out.ARF comes with paper construction manual including CG (2.75" back from the leading edge) and control throws.
What you will need to complete this airplane:
  • Transmitter / Receiver: You will need a 3-4 channel receiver, depending on how you power the receiver. If using a y-connector for the BEC, then you can use a 3 channel receiver. If not, use a four channel or higher receiver. Click here - Receivers for our full selection of 2.4GHz Hitec or full range 72MHz receivers

  • Servos - You will need 4 (for electric power) to 5 (for engine power) servos. We recommend HS-311 Economical Standard Servo (31311S) Hitec/JR/Air-Z or better.

  • Motor - A .25 to .32 glow engine or for electric brushless, we recommend the BP A2820-6 Brushless Outrunner Motor running the BP 45A Brushless ESC. Use a separate BEC. We recommend the Castle Creations BEC SWITCHING REGULATOR

  • Propeller - Use a 10 inch propeller for electric or a 9 inch propeller for glow. You can use either the APC 10 x 5 Thin Electric Gray Composite Propeller (LP10050E) or the APC 9 x 6 Sport-Props (LP09060)

  • Battery - For the electric motor setup, use the PolyQuest XQ Lithium Polymer 14.8V 3200mAh 30C

  • Receiver Battery (for glow setup)- Use a 4.8V to 6V receiver battery. Or you can use a A123 Nanophosphate 6.6V 2300mAh Receiver Pack with Male Servo S-Connector / Deans Ultra Plug, and PQ Balance Connector and a BP Battery Eliminator Circuit

  • Servo Extensions / Battery Connectors - You will need two 12 inch extensions and one Y connector. We offer servo extension wire with either the Futaba Style Connector/Color Wire or Hitec / JR Style Connector/Color Wire

  • . And for battery connectors, try Dean's Ultra plugs
  • Adhesives - You will need thin CA glue and 5 minute epoxy. These products can be found here Epoxy and CA Glues

  • Price: $45.00
    Currently Out Of Stock - Notify Me When Available or Special Order