View By Product Type
View By Manufacturer
Overstock Sales
Closeouts
2 to 10 Amp
15 to 55 Amp
60 to 240 Amp
BECs
Cheetah
Thunderbird
Hydra
ELE Speed Controllers
Edge
Edge Lite
Edge Lite HV
Edge HV
Feigao
Discontinued ESCs
Speed Controllers for Brushed Motors
Brushless Motor Connectors
 
Catalog > Speed Controllers & BECs > Feigao
Previous Item     Next Item     Show All Items      
Feigao 60-Amp Brushless Speed Controller (FG-BLESC-60A) - CLOSEOUT SALE
Item: 5 of 8  

Click on image for larger or alternate view.
  Weight:     60 grams / 2.1 oz  
  Size:     70 x 31 x 14 mm  
  Constant Current:     60 A  
  Max Current:     80 A burst  
  FET:     -  
  BEC:     5V / 3 A Switching  
  TIMING:     low / medium / high  
  PWM:     -  
  Input:     2-5 Li-Poly or 5-18 NiCd/NiMH  
  Low-Voltage Cutoff:     2.5V/2.75V/3.0V per cell Li-Poly
60%/65%/70% NiCd/NiMH  
This speed controller can be used in a helicopter. Use the soft start setting. This speed controller requires it to be armed before each use. It will not turn the motor until the throttle has moved all the way full and back down. This is an important safety feature that comes in handy when handling helicopters!
Features:
  • Programmable through transmitter or with the Feigao Speed Controller Programming Card (FG-ESCPC) (sold separately)
  • 5V Switching BEC (3A max) with noise choke - use up to 25V
  • Brake on/off
  • Hard/soft cut-off
  • 3 Li-Poly Auto-Cutoff voltages - 2.5V/2.75V/3.0V per cell
  • Normal/Soft/Super-Soft startup
  • Low/Medium/High timing
  • Safe start requires throttle stick to be fully down in order to arm motor
  • Alerts you when battery pack voltage is out of range or when throttle signal is out of range
  • Auto throttle shutoff on loss of signal
  • Thermal overload protection
  • Failed startup protection - automatically cuts power if motor fails to start
  • Special Instructions: Never exceed the recommended battery voltage listed on the package. Do not use a separate battery supply with this controller. Never disconnect the battery supply when the motor is running. We strongly suggest that you use an overload fuse in the battery circuit. For example, a motor will run at 4 amps therefore a 5 amp speed controller is adequate. If the motor is stalled or stopped, with the power on, then it will draw 15 to 20 amps and burn out the speed controller. An overload fuse can prevent this type of damage. Also, the BEC provides a regulated power supply to the receiver. Usually about .5 amps. A stalled servo can draw 2 or 3 amps and damage the BEC which in turn can cause damage to the receiver.
    NOTE: BP Hobbies assumes no responsibility for the improper use and installation of this product.
    Price: $37.60
    Currently Out Of Stock - Notify Me When Available or Special Order
    Prices, product specifications, and product availability are subject to change without notice.
    © Copyright 1998-2013, 2014 BP Hobbies, LLC. All rights reserved.