View By Product Type
View By Manufacturer
Overstock Sales
Closeouts
Beacon Adhesives
Blue Bird
Castle Creations
Chargery Products
Cheetah Motors and ESCs
Cheetah Packs
Corona
Du-Bro
Enkay
Excel
Feigao
Landing APC Props
Master Airscrew
HE Products
Hitec / Multiplex
Parson Adhesives
RCGF
SonicTronics
Tech-Aero Designs
 
Manufacturers > Feigao
Previous Item     Next Item     Show All Items      
Feigao 10-Amp Brushless Speed Controller (FG-BLESC-10A) - CLOSEOUT SALE
Item: 2 of 57  

Click on image for larger or alternate view.
  Weight:     11.2 g  
  Size:     22 x 18 x 4 mm  
  Constant Current:     10 A  
  Max Current:     13 A  
  BEC:     5V / 1.5 A  
  TIMING:     2-7 degree / 12-17 degree  
  Input:     2 to 3 cell Lipo  
  Low-Voltage Cutoff:     3.0 V per cell  
Features:
  • Programmable through transmitter or with the Feigao Speed Controller Programming Card (FG-ESCPC) (sold separately)
  • 1.5 Amp BEC - use up to 11.1V
  • Hard/soft cut-off
  • Li-Poly Auto-Cutoff voltage 3.0V per cell
  • Normal/Soft/Super-Soft startup
  • LowHigh timing
  • Safe start requires throttle stick to be fully down in order to arm motor
  • Alerts you when battery pack voltage is out of range or when throttle signal is out of range
  • Auto throttle shutoff on loss of signal
  • Thermal overload protection
  • Failed startup protection - automatically cuts power if motor fails to start
  • Instruction Manual
  • Special Instructions: Never exceed the recommended battery voltage listed on the package. Do not use a separate battery supply with this controller. Never disconnect the battery supply when the motor is running. We strongly suggest that you use an overload fuse in the battery circuit. For example, a motor will run at 4 amps therefore a 5 amp speed controller is adequate. If the motor is stalled or stopped, with the power on, then it will draw 15 to 20 amps and burn out the speed controller. An overload fuse can prevent this type of damage. Also, the BEC provides a regulated power supply to the receiver. Usually about .5 amps. A stalled servo can draw 2 or 3 amps and damage the BEC which in turn can cause damage to the receiver.
    NOTE: BP Hobbies assumes no responsibility for the improper use and installation of this product.
    Price: $10.10
    Currently Out Of Stock - Notify Me When Available or Special Order
    Prices, product specifications, and product availability are subject to change without notice.
    © Copyright 1998-2013, 2014 BP Hobbies, LLC. All rights reserved.