View By Product Type
View By Manufacturer
Overstock Sales
Beacon Adhesives
Blue Bird
Castle Creations
Chargery Products
Cheetah Motors and ESCs
Cheetah Packs
Landing APC Props
Master Airscrew
HE Products
Hitec / Multiplex
Parson Adhesives
Tech-Aero Designs
Manufacturers > Feigao
Previous Item     Next Item     Show All Items       Add To Shopping Cart      
Feigao 100-Amp Brushless Speed Controller (FG-BLESC-100A) - CLOSEOUT SALE
Item: 1 of 19  

Click on image for larger or alternate view.
  Weight:     120 grams / 4.2 oz  
  Size:     80 x 60 x 20 mm  
  Constant Current:     100 A  
  Max Current:     120 A burst  
  FET:     -  
  BEC:     None  
  TIMING:     low / medium / high  
  PWM:     -  
  Input:     1-6 Li-Poly or 3-18 NiCd/NiMH  
  Low-Voltage Cutoff:     2.5V/2.75V/3.0V per cell Li-Poly
60%/65%/70% NiCd/NiMH  
This speed controller can be used in a helicopter. Use the soft start setting. This speed controller requires it to be armed before each use. It will not turn the motor until the throttle has moved all the way full and back down. This is an important safety feature that comes in handy when handling helicopters!
  • Programmable through transmitter or with the Feigao Speed Controller Programming Card (FG-ESCPC) (sold separately)
  • Heavy Duty Heat Sink attached
  • Includes a six inch Y extension so you can plug in a separate BEC into one channel on your receiver
  • Mounting plate with four "ear holes" pre-attached
  • Brake on/off
  • Hard/soft cut-off
  • 3 Li-Poly Auto-Cutoff voltages - 2.5V/2.75V/3.0V per cell
  • Normal/Soft/Super-Soft startup
  • Low/Medium/High timing
  • Safe start requires throttle stick to be fully down in order to arm motor
  • Alerts you when battery pack voltage is out of range or when throttle signal is out of range
  • Auto throttle shutoff on loss of signal
  • Thermal overload protection
  • Failed startup protection - automatically cuts power if motor fails to start
  • Special Instructions: Never exceed the recommended battery voltage listed on the package. Do not use a separate battery supply with this controller. Never disconnect the battery supply when the motor is running. We strongly suggest that you use an overload fuse in the battery circuit. For example, a motor will run at 4 amps therefore a 5 amp speed controller is adequate. If the motor is stalled or stopped, with the power on, then it will draw 15 to 20 amps and burn out the speed controller. An overload fuse can prevent this type of damage. Also, the BEC provides a regulated power supply to the receiver. Usually about .5 amps. A stalled servo can draw 2 or 3 amps and damage the BEC which in turn can cause damage to the receiver.
    NOTE: BP Hobbies assumes no responsibility for the improper use and installation of this product.
    Price: $50.00
    Add To Shopping Cart    
    Prices, product specifications, and product availability are subject to change without notice.
    © Copyright 1998-2017, 2018 BP Hobbies, LLC. All rights reserved.