View By Product Type
View By Manufacturer
Overstock Sales
Closeouts
Eagle EPP
AirfoilZ / 3DX Hobbies
Multiplex AcroMaster
Multiplex Blizzard
Multiplex Cularis
Multiplex Dogfighter
Multiplex Easy Cub
Multiplex Easy Glider
Multiplex Easy Star
Multiplex Fun Cub
Multiplex FunJet
Multiplex FunJet Ultra
Multiplex Gemini Biplane
Multiplex Magister
Multiplex Mentor
Multiplex Merlin
Multiplex MiniMag
Multiplex Park Master 3D
Multiplex Twister Ducted Fan Jet
Multiplex Twin Star II
Multiplex Xeno
Multiplex Hawkeye
SIG AMA Cub Kit
Freewing FW 35 DF Jet
Lanyu Albatross ARF
Techone Mini P-51
 
Catalog > Airplane Kits, ARFs, and RTFs > Techone Mini P-51
Previous Item     Next Item     Show All Items      
Feigao 6-Amp Brushless Speed Controller (FG-BLESC-6A) - CLOSEOUT SALE
Item: 0 of 5  

Click on image for larger or alternate view.
  Weight:     5.3 grams / 0.19 oz.  
  Size:     29 x 12 x 6 mm / 1.14 x 0.47 x 0.23 in.  
  Constant Current:     6A  
  Max Current:     8A / 10 Sec.  
  FET:     -  
  BEC:     0.8A  
  TIMING:     Low/Medium/High  
  PWM:     -  
  Input:     2-3 cell Li-Poly or 5-9 Ni-MH  
  Low-Voltage Cutoff:     2.5V/2.75V/3.0V per cell Li-Poly
  60%/65%/70% NiCd/NiMH  
Features:
  • Programmable through transmitter or with the Feigao Speed Controller Programming Card (FG-ESCPC) (sold separately)
  • 0.8 Amp BEC - use up to 11.1V
  • Brake on/off
  • Hard/soft cut-off
  • 3 Li-Poly Auto-Cutoff voltages - 2.5V/2.75V/3.0V per cell
  • Normal/Soft/Super-Soft startup
  • Low/Medium/High timing
  • Safe start requires throttle stick to be fully down in order to arm motor
  • Alerts you when battery pack voltage is out of range or when throttle signal is out of range
  • Auto throttle shutoff on loss of signal
  • Thermal overload protection
  • Failed startup protection - automatically cuts power if motor fails to start
  • Instruction Manual
  • Special Instructions: Never exceed the recommended battery voltage listed on the package. Do not use a separate battery supply with this controller. Never disconnect the battery supply when the motor is running. We strongly suggest that you use an overload fuse in the battery circuit. For example, a motor will run at 4 amps therefore a 5 amp speed controller is adequate. If the motor is stalled or stopped, with the power on, then it will draw 15 to 20 amps and burn out the speed controller. An overload fuse can prevent this type of damage. Also, the BEC provides a regulated power supply to the receiver. Usually about .5 amps. A stalled servo can draw 2 or 3 amps and damage the BEC which in turn can cause damage to the receiver.
    NOTE: BP Hobbies assumes no responsibility for the improper use and installation of this product.
    Price: $8.19
    Currently Out Of Stock
    Prices, product specifications, and product availability are subject to change without notice.
    © Copyright 1998-2017, 2018 BP Hobbies, LLC. All rights reserved.