Bonds Depron, EPP, EPO, Balsa, Carbon Fiber, Elapor, and Polystyrene - No foaming, dries clear, stays flexible
This is one of the best adhesives on the market for adhering all of the common foams, plastics, and wood used in the RC Hobby. Once fully cured, the adhesive remains strong, flexible and waterproof.
HELPFUL HINTS
Less is more! Apply a thin line of Foam-Tac to surfaces; add more only if needed.
Foam-Tac's bond "welds" foam together for making invisible butt-joints & seams. Once cured, bond is stronger than the foam itself.
Great for reattaching broken ailerons.
Won't glue fingers together - not a cyanoacrylate.
Never leaves any residue on surfaces.
DIRECTIONS
All surfaces must be clean, dry, and free of dust and grease.
Remove white cap & save for storage. Screw on applicator tip & snip.
Apply a thin layer of glue to each side of materials to be joined.
Wait a few seconds and then firmly press parts together and immediately separate for 4-5 seconds more. Rejoin parts, firmly pressing surfaces together for a permanent bond.
Allow to dry for 20-30 minutes for a strong bond with a full cure within 24 hours or less.
ALWAYS REPLACE THE FLAT WHITE CAP AFTER EACH USE TO KEEP GLUE FROM THICKENING!
Click on the image below to see all of the products that Foam Tac can glue!
|