View By Product Type
View By Manufacturer
Overstock Sales
Beacon Adhesives
Blue Bird
Castle Creations
Chargery Products
Cheetah Motors and ESCs
Cheetah Packs
Landing APC Props
Master Airscrew
HE Products
Hitec / Multiplex
Parson Adhesives
Tech-Aero Designs
Manufacturers > Cheetah Motors and ESCs
Previous Item     Next Item     Show All Items      
Cheetah 30A Brushless ESC
Item: 4 of 109  
  Weight:     23.2 grams / 0.83 oz.  
  Size:     32 x 24 x 9 mm / 1.3 x 0.94 x 0.4 in.  
  Constant Current:     30A  
  Max Current:     40A / 10 Sec.  
  FET:     12  
  BEC:     3A  
  TIMING:     Auto  
  PWM:     8K  
  Input:     2-3 cell Li-Poly or 4-10 Ni-MH  
  Low-Voltage Cutoff:     Auto - 3.0V / cell Li-Poly
  0.8V / cell NiCd/NiMH  
  • Low resistance
  • 8khz PWM
  • For 4-10 NiCd/NiMH cells, 2-3 Li-Poly Cells
  • 30A Max on 3 Li-Poly
  • User programmable brake
  • User programmable low-voltage cutoff type (Lipo or NiCd/NiMH)
  • Throttle range self-adjusting
  • Soft start ramp up
  • Auto motor cutoff with reset
  • Safe power arming program ensures motor will not run accidentally after turn on
  • Low torque start
  • Auto shut down when signal is lost
  • Max RPM: 20,000 RPM with 14 pole motor
  • Note: If using 4 servos with 3-cell Li-Poly batteries, you will need a 4.8V receiver pack or an external switching BEC to provide power to your receiver.
    BP 30A Brushless ESC Programming Guide
    Special Instructions: Never exceed the recommended battery voltage listed on the package. Do not use a separate battery supply with this controller. Never disconnect the battery supply when the motor is running. We strongly suggest that you use an overload fuse in the battery circuit. For example, a motor will run at 4 amps therefore a 5 amp speed controller is adequate. If the motor is stalled or stopped, with the power on, then it will draw 15 to 20 amps and burn out the speed controller. An overload fuse can prevent this type of damage. Also, the BEC provides a regulated power supply to the receiver. Usually about .5 amps. A stalled servo can draw 2 or 3 amps and damage the BEC which in turn can cause damage to the receiver.
    NOTE: BP Hobbies assumes no responsibility for the improper use and installation of this product.
    Price: $19.95
    Currently Out Of Stock
    Prices, product specifications, and product availability are subject to change without notice.
    © Copyright 1998-2017, 2018 BP Hobbies, LLC. All rights reserved.